Program rca remote rcr311bt

If it is, congrats! If not, proceed to the next set of instructions. Press and hold the Code Search button on the universal remote control until the light turns on. Press the power button on the universal remote to send the next code to the equipment. Keep doing this until the equipment turns off. Press the Enter button on the universal remote to save the code. Test the remote to make sure everything works. If not, repeat the process. Looking for a new TV provider or streaming service?

Power on the equipment you want to control. While still holding the device button, press and hold the power button on the universal remote until the light turns off and on about three seconds. If all important buttons work, you're done. If not, try programming the remote with a different code. If your device's brand is not listed in the code tables, or if none of the codes listed for your brand work, try the Auto Code Search method below.

The remote will cycle through all codes present in its memory. The Auto Code Search method may take a long time, so, if your brand appears in the code lists you should try the Direct Code Entry method first.

If your component does not respond, continue to press the "PLAY" key every 5 seconds until your component turns off. This process continues until all of the codes have been searched. The remote exits search mode.

Step 7: When your equipment turns off, you'll know that the correct code is in the last block of 10 codes sent. The above method might take some extra time but it is very important to find your key code.

Once you have done the above procedure your remote should be working for all the in functions. The LED light indicates the device is ready to program. Brand new batteries check packaging for specific type 3. This handy guide and instructions 4. Patience See above! Throughout this article, we will guide you on how to program your remote control without a code.

But in case you simply need the codes, you can go here. To continue without a code, keep reading. Manually turn on your TV. Aim your remote at the TV panel and press and hold the TV button. Press the Play or the Slow button on your remote for five seconds. After this, your TV should turn off. If it does not turn the TV off, press the Play or Slow button again. Repeat this process every five seconds until the device turns off. Once the device turns off that means the remote control should be in sync with your TV.

If this process does not work, try to be patient. Just repeat these steps, making sure you are pressing the buttons the full time that is needed. The first thing you need to make sure is that your universal remote has an option for it. Say, for example, DVD, streaming device, Blu-ray, etc.

Here are the instructions you need to follow. Manually turn on the device you want to set up, making sure that your RCA universal remote is aiming towards it. Press and hold the button that matches the device you are pairing. Wait for the light on the remote to blink and then stay steady for you to follow the next step.